CLONE-A-WILLY GLOW IN THE DARK

25.800Ft
| /

With our DIY vibrator set, you can make an exact, vibrating silicone copy of any penis at home. Clone-A-Willy's kit captures incredible lifelike detail, making it the most personal sex toy on earth!

Instructions

  1. Open the tube, take everything out of it. Place the erect penis next to the tube so that the glans falls against the open end. Mark the tube 1.5 cm from the glans. Cut the tube at the mark.
  2. Turn on the TAP to 32 degrees C. It is important to get the water from the tap, do not microwave it or heat it on the stove, because it can easily overheat.
  3. Once the water is 32 degrees C, measure out 415 ml and pour it into the mixing bowl. Check the temperature, it needs to be EXACTLY 32 C!
  4. Set a timer for 45 seconds! Pour the shaping powder into the water and mix it to 45 MP, it's okay if you can't mix it completely smooth.
  5. Quickly pour the mixture into the tube and insert the erect penis. Do this as quickly as possible, within 2 minutes at the most.
  6. Hold the tube in place for 1-2 minutes, you will feel the casting material solidify.
  7. When the casting material has hardened, gently take the penis out of the tube and let the casting material harden further for 4-8 hours.
  8. Mix the two silicones together in a disposable bowl, using a wooden spatula to mix making sure to remove all the silicone from the box. For glow colors, add the illuminating powder to this step. Stir the silicone thoroughly for a few minutes.
  9. Pour out any water that may have collected at the bottom of the mold and very slowly pour the silicone into the mold.
  10. Cut a small X on the cardboard and press the vibrator up to the screw cap, don't push it through the paper.
  11. Fit the vibrator into the silicone so that the paper is level.
  12. Wait 24 hours for the DIY vibrator to be ready and then take it out of the mold.

If your penis is 22.8 cm or larger, you should use an XL vibrator and may need additional silicone. If you want to make a non-vibrating vibrator, you will definitely need extra silicone.

Tip 

A good penis ring will help you last longer and make the process fun!


Features 

Each Clone-A-Willy kit includes:

 

Bullet vibrator (1 speed)

 

Cloning kit

 

Silicone of your choice

 

Algae-based shaping powder

 

Casting cylinder (6.3 cm wide, 27.9 high)

 

The material of the vibrator is body-safe silicone, which is free of phthalates and latex.


Use & Cleaning

The product can be disinfected with lukewarm soapy water or cleaning agents developed for this purpose. Clean only with lint-free material.

 

Use only with water-based lubricants!